Home › Areas served › Ahuntsic › Camera Inspection
Camera Inspection in Ahuntsic: method, pricing, timelines
Between the Metropolitan Expressway and the streets of Ahuntsic, the same complaint returns every October: the dryer needs two cycles, then three. Almost always it is the duct that is the culprit, not the machine. A full camera inspection brushing takes 60 to 90 minutes with the vacuum set at the exterior outlet, and the difference shows on the first load.
How camera inspection works in Ahuntsic
The visit starts by unplugging the dryer and removing the transition duct, the short piece linking the machine to the wall. The camera is pushed through the first metres to film the real condition: lint, crushed elbows, forgotten objects. Then the rotary brush goes in, in 5-foot sections, all the way to the exterior outlet, while a 2,500-cubic-feet-per-minute vacuum hooked up outside captures the dislodged lint.
In Ahuntsic, the job always ends with an anemometer test: the outlet reading is compared against a new dryer's nominal airflow. The exterior flap is checked by hand, opened and closed three times, and lubricated with silicone if it sticks. You receive the before-and-after photos and the measurement log by email right after the visit.
The signs that trigger a visit in Ahuntsic
Three symptoms dominate calls from the Montréal: laundry still damp after a full cycle, a dryer that turns scorching hot at the end of a cycle, and a lingering burnt smell in the laundry room. Each sign points to airflow cut by 40 percent or more. A load that takes two hours to dry burns roughly 1.2 extra kilowatt-hours per load, an excess that wears the heating element out well before its time.
The calendar helps decide too: a full cleaning is recommended every 12 to 24 months for a family of four, and every 12 months if the dryer runs daily, if the duct exceeds 20 feet, or if a pet sheds heavily. Pre-2000 builds in Ahuntsic, with their riveted galvanized steel ducts, also collect rust scale that narrows the passage long before lint adds to it.
What the visit includes around Ahuntsic
For a single-family home in the Montréal, includes full duct brushing, outside vacuum, flap check and a before-and-after airflow reading logged in a photo report. A shared condo riser or a high roof outlet needs special access, spelled out in the quote before work starts. The camera inspection visit ends with a test cycle in front of you, dryer reconnected and flap checked.
After the visit, ConduitNet logs your home's measurements and reminds you of the next maintenance window based on declared usage. That follow-up prevents the classic Montréal scenario: a duct forgotten for five years, an emergency unblocking in January, and a dryer worn out well before its time.
Frequently asked questions
How much does camera inspection cost in Ahuntsic ?
The visit is quoted to measure based on duct length, elbow count and outlet access; the quote is free, detailed in writing, and the airflow reading is handed over on every visit.
How often should camera inspection be done in Ahuntsic ?
Every 12 to 24 months for an average household, every 12 months if the dryer runs daily or the duct exceeds 20 feet. Pre-1995 homes in Ahuntsic with original corrugated flexible duct gain from yearly checks until it is replaced with rigid.
Is outdoor access needed for camera inspection ?
Ideally yes: the vacuum hooks up to the exterior outlet so lint goes outside, never into your laundry room. In Ahuntsic, second-storey or roof outlets are reached with a telescopic ladder, no scaffolding, and most jobs wrap up within 90 minutes.